Product
Small parts, aligned to the same spatial logic. Rings, holders, drivers and cover plates connect every light and outlet to its surface and its system. Built from the inside out, so only the essentials show.
Small parts, aligned to the same spatial logic. Rings, holders, drivers and cover plates connect every light and outlet to its surface and its system. Built from the inside out, so only the essentials show.
Unifit forstner bit
Drill with care. For best results, apply painter's tape over the area to prevent tear-out, then use a drill press for accurate alignment and clean edges. If using a handheld drill, keep it perpendicular to the surface.
Always test on a scrap piece of wood before drilling the final workpiece. For flush installations, drill the 1-1/2" (Ø38 mm) countersink to a depth of 1/10" (2.5 mm), followed by the 1-3/8" (Ø35 mm) hole, ensuring both remain perfectly centered by not moving the workpiece between steps. Drill at moderate speed and avoid excessive pressure.
Alternatively, the countersink can be cut with a rabbeting router bit, for both single and duplex. Set the bit depth to 1/10" (2.5 mm) and rout around the pre-drilled or milled opening using a router table or plunge router.
This method offers consistent depth control and clean edges, making it a great option if you have a router available.
